Kenmore Pro 56043 Owner's Manual download pdf (Page 12)

WARNING: Risk of electrical shock. Electrical wiring must be done by qualiﬁ ed personnel in accordance

with all applicable codes and standards. Before connecting wires, switch power oﬀ at service panel and

lock service disconnecting means to prevent power from being switched on accidentally.

1. Connect cable using provided wire connectors.

Connect BLACK to BLACK, WHITE to WHITE and GREEN

or bare wire under GREEN ground screw.

DO NOT FORGET TO CONNECT THE GROUND.

CONNECT THE WIRING

CAUTION: The ORANGE wire (A) is for make-up

air device connection only. If there is no make-up

air device, never remove the cap on the ORANGE

wire end.

HE0088

2. Reinstall wiring cover.

INSTALL THE HOOD

CAUTION: Hold the hood until it is completely secured to the wood mounting strip.

1. Run power cable to installation location. Remove the

electrical compartment cover. Insert the cable in the hood

and tighten the wire clamp to secure the cable.

2. Rest the back cavity of the hood on the wood mounting

strip.

3. Secure the hood to wood mounting strip with 4 screws

no. 8 x 3/4" provided at locations shown. Drill (3) 3/16" size

holes into the drywall for wall anchors through the existing

holes in the inside hood back in the locations shown. Then,

install the three wall anchors with the remaining

no. 8 x 3/4" screws and the 3 washers provided.

WALL ANCHORS LOCATION

HD0603

MOUNTING SCREWS LOCATION

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Kenmore Pro 56043 Owner's Manual Page 12